Raytheon Full Time 2026 - Effector Power Design Engineer II

At Raytheon, the foundation of everything we do is rooted in our values and a higher calling – to help our nation and allies defend freedoms and deter aggression. We bring the strength of more than 100 years of experience and renowned engineering expertise to meet the needs of today’s mission and stay ahead of tomorrow’s threat. Our team solves tough, meaningful problems that create a safer, more secure world. 

Raytheon's Effector Analog & Power (EAP) Department is looking for junior to mid-level engineers who have power electronics knowledge to help design robust power systems. 

The EAP Department is responsible for the development, from concept to integration, of Telemetry and Flight Termination products; power systems from all up round to the lowest level power regulation; servo electronics supporting all mechanical motion in our products and low noise mixed signal electronics that provides the analog to digital interface to our front-end sensors. Each of these products generally operate in lower power and voltage ranges less than 10kW and 1000V. 

What You Will Do: 

• Design, analyze, simulate, test, and document power conversion (and related analog) circuitry. This circuitry will dominantly involve non-isolated and isolated switch mode power converters and linear converters. Main emphasis is on board-mounted power end use applications. 

• Help to see circuit card development through its design phases, from requirements definition through initial integration testing. 

• Test and validate circuit card designs by developing test procedures, performing data capture, and analyzing results to confirm adherence to project requirements. 

• Guide ECAD drafters through layout and routing activities, with moderate support from senior engineers. Assist in layer stackup definition. 

Qualifications You Must Have: 

• Masters degree in Electrical engineering or related science, Technology, Engineering, or Mathematics (STEM) is required

• Design, analysis, test, and/or simulation experience with one or more of the following non-isolated converter topologies: buck, boost, buck-boost. 

• Experience using tools such as MATLAB, MathCAD, Mathematica, or other similar tools. 

• Experience with analog electronics design, including at least one of the following: FETs/BJTs, op-amp, high/low/band pass filters, clock/data termination, and comparator circuits. 

• The ability to obtain and maintain a US security clearance is required. U.S. citizenship is required as only U.S. citizens are eligible for a security clearance. 

Qualifications We Prefer: 

• An advanced degree in Electrical Engineering 

• A self-starter, a quick learner, be able to function in a dynamic environment, and have good time management skills. Should have an appreciation for how successful teams are structured. 

• Experience communicating and documenting technical topics at the small team level. 

• Experience in any one of the following: 

• Familiarity with wide bandgap devices (SiC, GaN) in power electronics designs. 

• Simulators such as SIMPLIS or SABER, or Mentor Graphics DxDesigner, and/or Hyperlynx. 

• Acting as a liaison between program and functional management in a cross-matrixed organization. 

• Military specifications. 

• Design considerations for voltages > 400V and/or power > 10kW. Three-phase power systems, power factor control, and inverter/rectifier development. 

• Program management tools such as Earned Value. 

• Proposal development. 

Learn More & Apply Now! 

• This position requires a security clearance. DCSA Consolidated Adjudication Services (DCSA CAS), an agency of the Department of Defense, handles and adjudicates the security clearance process. More information about Security Clearances can be found on the US Department of State government website here: https://www.state.gov/m/ds/clearances/c10978.htm 

• Tucson, AZ: https://careers.rtx.com/global/en/raytheon-tucson,-az-location